Industrial Solutions
The plant-side half of the Fenner catalogue: drive belts, rotary and static seals, rubber hoses, paddy dehusking rolls and lubricants. Everything grouped here is a wearing part, so most enquiries begin with something that has already stopped a machine. SES holds the range as an authorised JK Fenner distributor, covering belt families Classical, wedge, cogged, banded, synchronous, ribbed; seal types Rotary shaft seals, O-rings, V-rings, hydraulic sets; hose service Hydraulic, water, air, steam, chemical; elastomers NBR, HNBR, CR, EPDM, FKM, silicone. Executions include power transmission belts, sealing solutions, hoses, rice rolls, among others. It is specified most often into fan and blower drives in boiler houses and kilns and crusher and conveyor drives in mineral handling. Every part is genuine JK Fenner through official channels, with designation, specification and options confirmed against your duty before it ships — supplied from Kolkata and our branch network, with breakdown cover that does not sit in an inbox.
Send an enquiry
Check Price & Availability.
Give us the size or the failed part — we reply on WhatsApp.
Trusted across Metals & Energy
Supplying India’s Industrial Names.
From integrated steel plants to power utilities and EPC majors — the works that cannot afford a counterfeit part specify through SES.
Covers
Belts, seals, hoses, rolls, lubricants
Duty
Continuous process plant
Ordered by
Section code, seal size, hose bore
Typical call
Breakdown replacement
Where it runs.
You will find Industrial Solutions in the parts of a plant where this particular duty actually occurs. In practice that means fan and blower drives in boiler houses and kilns, crusher and conveyor drives in mineral handling, pump and compressor rooms across process plant, and equally paddy dehusking lines in rice mills, hydraulic power packs on presses and shears, gearbox and pump sealing in rolling mills. What links them is the duty rather than the machine name — covers: Belts, seals, hoses, rolls, lubricants. If your installation is not on that list it matters less than you would think: the operating condition decides the specification. Send us the load, the speed, the running temperature and the environment it runs in, and we will match it to the right execution in the JK Fenner range and confirm what is in stock.
Specify it against the duty.
Specification here follows the operating condition, not the catalogue. You need to move power between two shafts at fixed ratio — Go to the belt families first. A timing belt where phase matters, a V-belt where slip on overload is acceptable protection. Fluid is escaping past a rotating shaft — Sealing solutions, sized by shaft diameter, housing bore and width in that order. Guessing the housing bore is the commonest cause of a repeat leak. Fluid has to travel between two points that move relative to each other — Hoses, selected on working pressure and the fluid carried. A water hose pressed into oil service swells and delaminates within weeks. Where two of those apply at once, specify for the harsher of the two — under-specifying is what puts the part back on the bench a month later. Send us the duty and we will confirm the execution.
Ordering this from SES.
Photograph the old part before it goes in the scrap bin. A legible section marking on a belt flank or a size code on a seal case settles an enquiry in minutes, where measuring a worn part rarely does.