SKF RecondOil
An oil regeneration technology that separates out very fine particles, including sub-micron contamination that conventional filtration passes. Cleaned oil goes back into the system, so the same charge stays in service far longer instead of being drained and replaced. SES holds the range as an authorised SKF distributor, covering separation Removes fine and sub-micron particles from the oil; deployment Offline loop, mobile unit or installed system; fluids Hydraulic, gear, turbine and metalworking oils; verification Cleanliness code measurement before and after treatment. Executions include offline kidney-loop regeneration units, mobile units for periodic treatment, permanently installed systems on large reservoirs, service-based oil regeneration arrangements. It is specified most often into hydraulic systems on large presses and forging lines and circulating oil systems on mill and kiln gearboxes. Every part is genuine SKF through official channels, with designation, specification and options confirmed against your duty before it ships — supplied from Kolkata and our branch network, with breakdown cover that does not sit in an inbox.
Send an enquiry
Check Price & Availability.
Give us the size or the failed part — we reply on WhatsApp.
Trusted across Metals & Energy
Supplying India’s Industrial Names.
From integrated steel plants to power utilities and EPC majors — the works that cannot afford a counterfeit part specify through SES.
Removes
Fine and sub-micron particulate conventional filters pass
Outcome
Oil charge reused rather than drained
Suits
Large oil volumes with a real disposal cost
Measure
Cleanliness code before and after
Where it runs.
You will find SKF RecondOil in the parts of a plant where this particular duty actually occurs. In practice that means hydraulic systems on large presses and forging lines, circulating oil systems on mill and kiln gearboxes, metalworking fluid and cutting oil systems in machine shops, and equally rolling oil circuits on cold mills, turbine and compressor lubrication oil charges. What links them is the duty rather than the machine name — removes: Fine and sub-micron particulate conventional filters pass. If your installation is not on that list it matters less than you would think: the operating condition decides the specification. Send us the load, the speed, the running temperature and the environment it runs in, and we will match it to the right execution in the SKF range and confirm what is in stock.
Specify it against the duty.
Specification here follows the operating condition, not the catalogue. Oil analysis showing rising particle counts despite fresh filters — Regeneration rather than another filter change. Particles below the filter rating accumulate freely, and they are the ones abrading bearing and valve surfaces. Large oil volume changed on a fixed calendar schedule — A condition-based drain interval supported by regeneration and regular analysis. Time-based changes dump serviceable oil and, more often than not, leave the dirt behind in the system anyway. Machine suffering repeated servo or proportional valve faults — Cleanliness targets set for the valves, with regeneration sized to hold them. These valves have clearances measured in a few microns and they fail on contamination long before the pump complains. Where two of those apply at once, specify for the harsher of the two — under-specifying is what puts the part back on the bench a month later. Send us the duty and we will confirm the execution.
Ordering this from SES.
Take a proper sample from a live line before you start, and take it the same way every time afterwards. Regeneration is judged on a trend, and samples drawn from the bottom of a settled tank one week and a running line the next will show noise rather than a result.