Wall Chaser and Handheld Concrete Grinder
Twin-blade chasers that cut a parallel slot for conduit and pipework, and hand grinders running diamond cup wheels to level and clean concrete. Both work dry and both depend on extraction to perform. SES holds the range as an authorised Tyrolit distributor, covering chase width Adjustable through blade spacing and spacers; chase depth Adjustable against a positive depth stop; chaser blades Common wall-chase diameters, paired sets; grinder wheels Diamond cup wheels, single and double row. Executions include wall chasers, chaser blade sets and spacers, hand-held concrete grinders, diamond cup wheels, among others. It is specified most often into chasing conduit runs in plant and substation walls and slotting masonry for water and drain pipework. Every part is genuine Tyrolit through official channels, with designation, specification and options confirmed against your duty before it ships — supplied from Kolkata and our branch network, with breakdown cover that does not sit in an inbox.
Send an enquiry
Check Price & Availability.
Give us the size or the failed part — we reply on WhatsApp.
Trusted across Metals & Energy
Supplying India’s Industrial Names.
From integrated steel plants to power utilities and EPC majors — the works that cannot afford a counterfeit part specify through SES.
Chaser
Twin blades, adjustable width and depth
Grinder
Diamond cup wheel in a shrouded guard
Dust
Extraction essential, silica exposure
Drive
Electric, hand held
Where it runs.
You will find Wall Chaser and Handheld Concrete Grinder in the parts of a plant where this particular duty actually occurs. In practice that means chasing conduit runs in plant and substation walls, slotting masonry for water and drain pipework, levelling formwork fins and lines on RCC surfaces, and equally removing coatings and adhesive residue in corners, preparing concrete for repair mortar or bonding agents, grinding back high spots at slab joints. What links them is the duty rather than the machine name — chaser: Twin blades, adjustable width and depth. If your installation is not on that list it matters less than you would think: the operating condition decides the specification. Send us the load, the speed, the running temperature and the environment it runs in, and we will match it to the right execution in the Tyrolit range and confirm what is in stock.
Specify it against the duty.
Specification here follows the operating condition, not the catalogue. Conduit of a known outside diameter — Chase width set once, to conduit plus cover allowance. Widening a chase by eye afterwards breaks out the wall face. Reinforcement close to the wall surface — Depth limited from a cover meter reading. A chaser that cuts a bar in a structural wall turns a services job into a repair job. Grinding right into a corner or up to a wall — A segmented cup wheel with a guard that opens on one side. A fully closed shroud leaves an untouched border you then have to chip out by hand. Where two of those apply at once, specify for the harsher of the two — under-specifying is what puts the part back on the bench a month later. Send us the duty and we will confirm the execution.
Ordering this from SES.
Two chase blades wear unevenly if one consistently leads the cut. Rotate them at every change so the pair stays matched, otherwise the slot comes out stepped and the conduit will not sit flat. Send the designation off the failed part and we will confirm the Tyrolit equivalent and stock position.