Wire Brushes
Cup, wheel, end and hand brushes for taking off scale, spatter, rust and coatings ahead of the abrasive stage. The wire cleans by impact, so the surface comes up bright without measurable stock loss. SES holds the range as an authorised Tyrolit distributor, covering cup diameters Roughly 65 mm to 100 mm for angle grinders; wheel diameters Die-grinder sizes through to bench diameters; filament gauge Fine for finishing, heavy for descaling; knot styles Twist knot and cable twist. Executions include crimped cup brushes, knotted cup brushes, wheel brushes, end brushes, among others. It is specified most often into interpass cleaning between weld runs on pressure parts and removing spatter from structural steel before galvanising. Every part is genuine Tyrolit through official channels, with designation, specification and options confirmed against your duty before it ships — supplied from Kolkata and our branch network, with breakdown cover that does not sit in an inbox.
Send an enquiry
Check Price & Availability.
Give us the size or the failed part — we reply on WhatsApp.
Trusted across Metals & Energy
Supplying India’s Industrial Names.
From integrated steel plants to power utilities and EPC majors — the works that cannot afford a counterfeit part specify through SES.
Forms
Cup, wheel, end, hand
Action
Impact cleaning, negligible stock removal
Wire
Carbon steel, stainless, brass
Drive
Angle grinder, straight grinder, bench
Where it runs.
You will find Wire Brushes in the parts of a plant where this particular duty actually occurs. In practice that means interpass cleaning between weld runs on pressure parts, removing spatter from structural steel before galvanising, cleaning boiler tube surfaces during a shutdown, and equally weld seam preparation on stainless dairy and food fabrication, bench cleaning of small castings in the machine shop, de-rusting base frames and anchor plates on site. What links them is the duty rather than the machine name — forms: Cup, wheel, end, hand. If your installation is not on that list it matters less than you would think: the operating condition decides the specification. Send us the load, the speed, the running temperature and the environment it runs in, and we will match it to the right execution in the Tyrolit range and confirm what is in stock.
Specify it against the duty.
Specification here follows the operating condition, not the catalogue. Cleaning immediately before a coating that must adhere — A trim and gauge that leaves a keyed surface rather than a burnished one. A worn-down brush polishes steel and the primer then peels away in sheets. Brush fitted to a straight or die grinder — Arbor size and rated speed checked together. Straight grinders spin far faster than angle grinders and an over-speeded wheel brush throws wire. Confined space or sustained overhead work — End brushes on a flexible shaft in place of a large cup. A cup brush held at arm reach cannot be kept flat and wears away on one side. Where two of those apply at once, specify for the harsher of the two — under-specifying is what puts the part back on the bench a month later. Send us the duty and we will confirm the execution.
Ordering this from SES.
Break a new knotted brush in for a minute against scrap before it goes on the job. The loose filaments come out then, instead of into the operator once the brush is at full load. Send the designation off the failed part and we will confirm the Tyrolit equivalent and stock position.